[Hardware] Status on FPGA PCB

Kris Amy kris at amy.id.au
Tue Dec 5 00:58:51 EST 2006


A grand for 2 or 8?

Seems expensive if it goes from 200 for 1 to 1k for 2.

Cheers,
Kris

-----Original Message-----
From: John L. Bass [mailto:jbass at dmsd.com] 
Sent: Tuesday, 5 December 2006 10:32 AM
To: hardware at lists.distributed.net; kris at amy.id.au
Subject: Re: [Hardware] Status on FPGA PCB

Kris> Does that mean you will be running 8 FPGA's @ 240mkeys/sec ?

Guerric is looking at his core on the Spartan-3 (which is a bit slower
than Virtex-4 parts) and without optimization, is about 1/2 the speed
of the Virtex-4 at 1/4 of the price, making it very affordable.

Best case numbers for the Spartan-3 using pencil and paper are about
250MKeys/second for BRam based designs, and I expect we can probably
get a good piece of that with tuning over time.

I have some serious questions about how to handle heat on Spartan-3's
which will require a prototype (or two) to resolve. I suspect the
octal design I did for the prototype may not be stable, but I wanted
to give it a try anyway. I am pretty confident that that single sided
mesh design can be made stable, so this board is useful to test both
configurations.

Kris> Also what was the cost to build this?

A little over a $100/fpga. Something around $150-200 for one, and about
a grand for two by the time we add eeproms/flash, power supplies, cap's,
board, and connectors in.

I'm excited ... I didn't realize high end Spartan-3's were this cheap and
performance rich for the dollar when applied to reconfigurable computing.

Have fun,
John



More information about the Hardware mailing list